Virtual Console FCD-CFxx Informations techniques télécharger pdf (Page 404)

100

101

3.1.25.30 USR0173 : "The Front Panel USB port switched automatically from iDRAC to

operating system."

3.1.25.31 USR0174 : "The Front Panel USB device is removed from the operating system."

3.1.25.32 USR0175 : "The Front Panel USB Port Over Current is detected for the attached

device on Disk.USBFront.<port number>."

When event is generated, message will have the following substitutions:

• <port number> = "Port"

3.1.25.33 USR0176 : "The Front Panel USB Port Over Current condition is cleared for the

attached device Disk.USBFront.<port number>."

When event is generated, message will have the following substitutions:

• <port number> = "Port"

3.1.25.34 USR0177 : "Configuring the Front Panel USB Port Mode to Automatic because the

iDRAC is unable to retrieve the Front Panel USB Port Mode."

3.1.25.35 USR0180 : "The Quick Sync feature is enabled because the activate button on the

bezel was pressed."

3.1.25.36 USR0181 : "The Quick Sync feature is deactivated because the inactivity timeout

limit was reached."

3.1.25.37 USR0182 : "Server information has been accessed by using the iDRAC Quick Sync

feature."

3.1.25.38 USR0183 : "A bezel with the iDRAC Quick Sync feature is detected."

3.1.25.39 USR0184 : "A bezel with the iDRAC Quick Sync feature has been disconnected and

the feature is not available."

3.1.25.40 USR0190 : "Peak value is reset for <sensor type> sensor."

When event is generated, message will have the following substitutions:

• <sensor type> = "SensorType"

3.1.25.41 USR8500 : "Excessive login failures from <IP address>; blocked for <number>

seconds."

When event is generated, message will have the following substitutions:

• <IP address> = ""

3.1.25.42 USR8501 : "Successfully closed Session process: pid=<process ID> sid=<session

ID>"

When event is generated, message will have the following substitutions:

404

1 2 ... 399 400 401 402 403 404 405 406 407 408 409 ... 919 920

Virtual Console FCD-CFxx Informations techniques Page 404

Commentaires sur ces manuels